Charge Level Display On The Lcd Panel; Insertion/Removal Of Memory Cards; Cf Cards - Leica S3 Instruction Manual

CHARGE LEVEL DISPLAY ON THE LCD PANEL

EN
Display Charge status
approx. 88 - 100%
approx. 63 - 87%
approx. 47 - 62%
approx. 36 - 46%
approx. 26 - 35%
approx. 0 - 25%
The battery needs charging or replacing
20

INSERTION/REMOVAL OF MEMORY CARDS

You can use 2 card types simultaneously in the Leica S3 to store
recorded data. It has one card slot for SD/SDHC/SDXC (secure digital)
and one for CF (compact flash up to UDMA 7) cards.
Notes
• SD/SDHC/SDXC memory cards are available from various suppliers in
various sizes and with differing read/write speeds. Memory cards with
high storage capacities and high read/write speeds offer quick storage
and rendering.
• Memory cards with a capacity of less than 1GB are not supported.
Memory cards with capacities between 1GB and 2GB must be
formated before first use.
• Check the memory card for correct alignment if you are having
difficulties inserting it into the camera.
Open the cover 11
▸ Push the cover backward and flip it open on the right
Close the cover 11
▸ Close the cover and push forward until it clicks into place

CF CARDS

▸ Make sure that the camera is switched OFF (see p. 24)
Insertion 1
▸ Push the memory card as far as it will go into the slot with the contacts
facing towards the camera and the front of the card facing the front of
the camera
21a
▸ Make sure that the ejector pin is fully pushed in
Important
Do not use excessive force! Excessive force can damage the internal
contacts in the memory card slot.