Table of Contents
Advertisement
Danfoss ECtemp 316
Follow the steps below to mount the thermostat:
1.
Click the thermostat on to the DIN rail attachment.
2.
Connect the thermostat according to the connection
diagram.
The screen of the heating cable must be connected
to the earth conductor of the power supply cable by
using a separate connector.
Note: When you use the wire sensor for floor heating,
always install the sensor in a conduit.
3.
Turn on the power supply.
Protective separation
The thermostat is designed so that the sensor circuit is gal-
vanically separated from the high voltage part which means
that the sensor part is regarded as a low voltage part.
Installation Guide
Danfoss A/S
Ulvehavevej 61
7100 Vejle
Denmark
IP20
D316
-10T50
7
Advertisement
Table of Contents
