General Warnings; Preservation Of The Documentation; Installation; Warranty - AERMEC WRL 200 Technical Manual

Standards and directives to be followed
in the design and manufacture of the
unit:
STANDARD
1. UL 1995 Heating and
cooling equipment
2. ANSI/NFPA Standard 70 National
Electrical code (N.E.C.)
3. CSA C.22.1.- C.22.2 Safety Standard
Electrical Installation
SAFETY LEVEL
1. IP24
ACOUSTIC PART
1. ISO DIS 9614/2 (sound intensity
method)
REFRIGERANT GAS (R410A)
This unit contains fluorinated gre-
enhouse gases covered by the Kyoto
Protocol. Maintenance and disposal
operations must be only carried out
by qualified staff, in compliance with
existing laws.
ATTENTION
Tampering, removal, lack of the
identification plate or other does
not allow the safe identification
of the product and will make
any installation or maintenance
operation to be performed difficult.
IWRLPY. 1403. 5890710_01
4
1.

GENERAL WARNINGS

The WRL AERMEC units are constructed
according to the recognised technical
standards and safety regulations. They are
designed for summer and winter conditioning
and the production of domestic hot water.
Any contractual or extracontractual liability
of the Company is excluded for injury/
damage to persons, animals or objects owing
to installation, regulation and maintenance
errors or improper use. All uses not expressly
indicated in this manual are prohibited.
1.1. PRESERVATION OF THE
DOCUMENTATION
The instructions along with all the related
documentation must be given to the user of
the system, who assumes the responsibility
to conserve the instructions so that they are
always at hand in case of need.
Read this sheet carefully; the execution of all
works must be performed by qualified staff,
according to Standards in force on this subject
in different countries. (Ministerial Decree
329/2004).
1.2.

INSTALLATION

The unit must be installed in such a way that
maintenance and/or repairs can be carried out.
2.

PRODUCT IDENTIFICATION

The units can be identified through:
• PACKING LABEL which shows the
product identification data
• TECHNICAL PLATE
2.1.

TECHNICAL PLATE POSITION

1.3.

WARRANTY

The appliance warranty does not cover the
costs for ladder trucks, scaffolding, or other
elevation systems that may become necessary
for carrying out servicing under warranty.
Do not modify or tamper with the unit as
dangerous situations can be created and the
manufacturer will not be liable for any damage
caused. The validity of the warranty shall be
void in the event of failure to comply with the
above-mentioned indications.
1.4. WARNINGS REGARDING SAFETY AND
INSTALLATION STANDARDS
• The unit must be installed by a qualified
and suitably trained technician, in compli-
ance with the national legislation in force
in the country of destination (Ministerial
Decree 329/2004).
AERMEC will not assume any re-
sponsibility for damage due to fail-
ure to follow these instructions.
• Before beginning any operation, READ
THESE INSTRUCTIONS CAREFULLY AND
CARRY OUT THE SAFETY CHECKS TO
AVOID ALL RISKS. All the staff involved
must have thorough knowledge of
the operations and any dangers that
may arise at the moment in which the
installation operations are carried out.
example of technical plate