Troubleshooting - TALAMEX X Series Manual

Troubleshooting

Symptom
Power loss
Excessive noise, vibration
Motor Motor failure (all speeds)
niet (alle toerentallen)
Motor failure (one or more
speeds)
Difficulty removing propeller
Possible Cause
Weak battery
Loose or corroded battery
connections
Propeller is loose, damaged, or off-bal-
ance
Wiring or electrical connection faulty
Weeds, fishing line, or debris wrapped
around propeller
Motor shaft is bent
Propeller is loose, damaged, or off-bal-
ance
Weak battery
Loose or corroded battery
connections
Electrical
Fuse on circuit breaker is open
Propeller is loose, damaged, or off-bal-
ance
Wiring or electrical connection faulty
Bent propeller pin
Bent armature shaft
Resolution
Refer to Wiring and Battery
Information.
Refer to Maintenance.
Wire gauge from the battery to
the trolling motor is insufficient.
Six-gauge wire is
recommended.
Remove weeds, fishing line, or
debris from propeller.
Refer to Warranty Information.
Refer to Maintenance.
Refer to Wiring and Battery
Information.
Check the connector for a loose
or damaged connection. Refer
to Wiring and Battery Information.
Replace the fuse or reset the
circuit breaker only after
determining the root cause of
the problem.
Refer to Maintenance.
Refer to Warranty
Information.
Hold one blade and lightly tap
the opposite blade with a
rubber mallet.
Use a putty knife on both sides
of the propeller to apply equal
pressure.
Refer to service center.
35