Table of Contents
Advertisement
C3A, C6A, C6A HD Video Colposcope User Manual
18 No part of the device is intended to be maintained by the user. Unauthorized
servicemen shall not open the enclosure. Otherwise, safety hazards may happen.
19 The camera light source is very bright. When the camera is on, do not stare at the
light source or aim the light source at the patient's eyes.
20 The system is not for diagnosis or treatment, and it is a non-contact examination
device. It should not touch the patient during examination.
21 The mains plug is used as isolation means from supply mains. Position the device in
a location where the operator can easily access the disconnection device.
22 The device should not be used adjacent to or stacked with other equipment and that
if adjacent or stacked use is necessary, the device should be observed to verify
normal operation in the configuration in which it will be used.
23 The medical electrical equipment needs to be installed and put into service according
to the EMC Information provided in this user manual.
24 Portable and mobile RF communications equipment can affect medical electrical
equipment, refer to section A4.4 Recommended Separation Distances.
25 Do not service or maintain the device or any accessory which is in use with a patient.
26 Assembly of the device and modifications during actual service life shall be evaluated
based on the requirements of IEC60601-1.
1
The device is designed for continuous operation. Do not water the device.
2
Keep the environment clean. Makethe device far from corrosive medicine, dust area,
high-temperature and humid environment.Avoid vibration. Do not move it with the
power cord connected.
3
Do not operate the device if it is damp or wet because of condensation or spills. Avoid
using the device immediately after moving it from a cold environment to a warm,
humid location.
4
Do not sterilize the device or any accessory with autoclave or gas.
5
Do not plug any undefended USB device into the computer in which the video
colposcope software has been installed. Make sure that the connected USB device
is free of viruses.
6
If the computer in which the video colposcope software has been installed will be
connected to the network, install genuine antivirus software to protect the computer
against viruses.
7
Do not change the time of the system unless necessary, otherwise the appointment
data may be lost.
8
The device and accessories are to be disposed of according to local regulations after
their useful lives. Alternatively, they can be returned to the dealer or the manufacturer
for recycling or proper disposal.
WARNING
CAUTION
- 3 -
Safety Guide
Advertisement
Table of Contents
