Prohibit Frequency Parameters; Motor Potentiometer; Adjust Reference - Vacon apfiff09 marine Applications Manual

60 • VACON®
Open loop torque
P2.2.9.11.3 controller
I gain
Table 6-6. Torque reference open loop settings, G2.2.9.12

6.2.5 Prohibit frequency parameters

Code Parameter
P2.2.10. Prohibit frequency
1 range 1 low limit
P2.2.10. Prohibit frequency
2 range 1 high limit
P2.2.10.
Ramp time factor
3
Table 6-7. Prohibit frequencies, G2.2.10

6.2.6 Motor Potentiometer

Code Parameter
P2.2.11. Motor potentiometer
1 ramp rate
Motor potentiometer
P2.2.11.
frequency reference
2
memory reset
P2.2.11. Motor potentiometer
3 reference copy
Table 6-8. Motor potentiometer, G2.2.11

6.2.7 Adjust Reference

Code Parameter
P2.2.12.1 Adjust input
P2.2.12.2 Adjust minimum
P2.2.12.3 Adjust maximum
Table 6-9. Reference adjustment settings, G2.2.12
0 32000
Min Max Unit
-1.00 320.00 Hz
0.00 320.00 Hz
0.1 10.0 x
Min Max Unit
0.10 2000.00 Hz/s
0 3
0 2
Min Max Unit
0 5
0.0 100.0 %
0.0 100.0 %
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
10 640
Default Cust ID
0.00 509
0.00 510
1.0 518
Default Cust ID
1.00 331
1 367
0 366
Default Cust ID
0 493
0.0 494
0.0 495
apfiff09 marine
Note
0=Not used
0=Not used
Multiplier of the currently
Selected ramp time
between prohibit
frequency limits.
Note
Ramp rate for motor
potentiometer
0=No reset
1=Reset in stop state
2=Reset in powered down
3=StopReq;Fout
0=No copy
1=Copy Reference
2=Copy output frequency
Note
0=Not used
1=AI1
2=AI2
3=AI3
4=AI4
5=Fieldbus
Adjust limit to decrease
ref.
Adjust limit to increase
ref.