Switching Between Modes; Device Washing; Temperature Calibration - Lifecanvas Technologies SmartBatch+ User Manual

15. Always wash the device after use before turning off the power to prevent detergent
buildup.

Switching Between Modes

It is simple to switch between labeling and clearing modes.
1. Remove any Sample Cups and samples from the system.
2. Wash the device.
3. Begin processing samples with your new mode following the instructions for that
particular function.

Device Washing

Follow these steps to wash the device.
During these steps it is important to not run the Auxiliary Power without any liquid in the
system. It could potentially damage the pump.
1. Turn off Auxiliary Power.
2. Drain any liquid out of the system with the Drainage Valve and close the valve.
3. Pour 400 mL distilled water into the Chamber.
4. Turn on Auxiliary Power and run the pump for several minutes.
5. Turn off Auxiliary Power and drain the liquid.
6. Repeat steps 3-5 at least 3 more times, or until the liquid in the Chamber is no longer
bubbly.

Temperature Calibration

We recommend re-calibrating the temperature sensors every 6 months to maintain proper
system function and to ensure the best results. For the best results, use a well calibrated digital
thermometer to collect temperature measurements.
1. Fill the device with 400 mL distilled water and turn on the Auxiliary Power.
2. Open the Case Lid and Chamber Lid.
3. Put the thermometer into the Chamber at an angle and close the Chamber Lid such that
the thermometer is still in the liquid, and the sensor on top of the Chamber Lid points
down into the liquid.
4. Wait ~30 seconds for the temperature to stabilize.
5. Press the "Mode" button so the indicator shows "Cal". This means that the device is in
calibration mode.
www.lifecanvastech.com info@lifecanvastech.com
14