Yamaha XSR900 Owner's Manual page 77

1. O-ring
TIP
Make sure that the O-ring is properly
seated.
6. Install the new oil filter cartridge,
and then tighten to the specified
torque.
1
1. Torque wrench
Periodic maintenance and adjustment
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
7. Install the engine oil drain bolt with
a new gasket, and then tighten the
bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 32 lb·ft)
8. Pour the specified amount of the
recommended oil into the crank-
case.
TIP
Using a funnel is recommended.
9. After checking the engine oil filler
cap O-ring, install the filler cap.
TIP
Wipe off any spilled oil before starting
the engine.
10. Start the engine and let it idle while
checking for oil leaks.
TIP
If any oil leaks are found which you
cannot fix, have the vehicle inspected.
8-14
11. Stop the engine, wait a few min-
utes for the oil level to settle, and
then check the oil level one last
time. NOTICE: Do not operate
the vehicle until you know that
the engine oil level is suffi-
cient.
[ECA10012]
1
2
3
4
5
6
7
8
9
10
11
12
13