Extron electronics FOX3 Matrix Series Setup Manual page 4

FOX3 Matrix Series • Setup Guide (Continued)
FOX3 Matrix 24x, 40x, 80x, 160x —
• 100-240 VAC, 50-60 Hz power source.
• Connect via standard IEC power cord.
FOX3 Matrix 320x only —
North America —
• Nominal 120 VAC, 60 Hz, 20 A protected power source.
OR
• Nominal 240 VAC, 60 Hz, 15 A minimum protected power source.
• Connect via C19 power cord with NEMA 5-20 plug or 240V NEMA 6-20 plug.
Other regions –
• 100-120 VAC, 50-60 Hz, 15 A protected power source. Connect via C19 power cord and
a plug configuration of 15 A minimum.
OR
• 200-240 VAC, 50-60 Hz, 13 A or 16 A protected power source. Connect via C19 power
cord and a plug configuration of 7 A minimum.
FOX3 Matrix 560x and 840x —
North America — Terminated AC power cord
• Single phase, 200-240 VAC, 50-60 Hz, 20 A protected power source.
• Connect the 9.85 feet (3 m) terminated power cord to a NEMA L6-20R single phase
220 VAC, 60 Hz, 20 A protected power source.
Other regions — Unterminated AC power cord
• Single phase, 200-240 VAC, 50-60 Hz, 20 A protected power source.
• Have either a licensed electrician or qualified personnel terminate the AC power cord with
a region-specific power plug (not included). Ensure the wiring is in accordance with local
electrical codes.
• Connect the 9.85 feet (3 m) terminated power cord to a single phase 200-240 VAC,
50-60 Hz, 20 A protected power source.
ATTENTION:
• For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-)
contacts.
• Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS connecter les manchons aux contacts
négatifs (–).
H Audio Inputs (see figure 2
audio input devices to an audio 5-pole captive screw
port (see figure 4 to wire the captive screw connector).
I Audio Outputs — Connect audio output devices to an
audio 5-pole captive screw port (see figure 4 to wire
the captive screw connector).
J
DMP Expansion port and LED —
• Expansion Port — Connect an STP cable between
this port and the Expansion port on an optional
Extron DMP Digital Matrix Processor for digital audio connection. Receive and transmit eight 2-channel stereo inputs and
eight 2-channel stereo outputs via this RJ-45 connection.
• Link LED — Lights to indicate that the port is connected to a compatible device.
NOTE: Only connect Extron non-AT audio devices to the DMP Expansion port.
4
on page 2) — Connect
Tip
Ring
Tip
Sleeve Sleeves
Tip
Tip
Sleeve
Ring
Unbalanced Stereo Input
No Ground Here
Tip
Ring
Tip
Sleeves Sleeves
Tip Tip
Ring
No Ground Here
Unbalanced Stereo Output Balanced Stereo Output
Figure 4.
Audio Input Wiring Diagram
L6-20R
North America
X
G
Y
X: Hot Y: Hot
G: Ground
Balanced Stereo Input
Do not tin the wires!