Polaris PROSPECTOR PRO 2.0 User Manual page 24

MAINTENANCE
LUBRICATION
The maintenance chart on page 17 includes
lubrication maintenance to perform on the
Track Systems. Refer
recommendations for optimal lubrication.
NOTE: Use a grease designed for operation in cold
temperature and
environments.
REFERENCE "A"
WHEEL SEAL LUBRICATION (Ø202 mm &
wide Ø134 mm wheels)
Install new seal on clean, dry wheel shaft at
position shown below.
NOTE: Installing new wheel seals is recommended
when lubricating these components.
Apply evenly 3 to 3.5 cc of grease all around the
wheel seal's V–shaped groove.
NOTE: V-shaped groove must be filled with grease all
around.
21
to the following
in extreme and wet
WHEEL SEAL LUBRICATION (narrow Ø134
mm wheels)
Install new seal on clean, dry wheel shaft at mid-
point on bearing seat.
NOTE: Installing new wheel seals is recommended
when lubricating these components.
Apply evenly 3 to 3.5 cc of grease all around the
wheel seal's V–shaped groove.
NOTE: V-shaped groove must be filled with grease.