Mx3X, Mx3-Rfid - LXE 9000A3775 User Manual

MX3 Battery Charger Versions
Important:

MX3X, MX3-RFID

The MX3X uses the following battery: MX3A378BATT (LXE part no. 158224-0001).
The MX3-RFID uses the following battery: MX3A380RFIDBATT (LXE part no. 159922-0001)
The MX3 MultiCharger Plus is designed to charge and anylyze these batteries. To ensure proper
charging, examine the label on the back of the MX3 MultiCharger.
LXE Part No.
157360-0126
157360-0001
157360-0001
Note:
MX3 Multi-Charger Plus
9000A377CHGR5WW (with power cord)
9000A377CHGR5WW (power cord not included)
Use LXE V1.01 Upgrade Kit
Likewise, the MX3 Multi-Charger can be used to recharge MX3X and MX3-RFID batteries when
equipped with the V1.20 or greater upgrade kit. The MX3 Multi-Charger can charge up to 6
batteries simultaneously. It does not have a battery analyzer feature. Versions of the MX3 Multi-
Charger without the V1.20 upgrade kit can charge the MX3X and MX3-RFID batteries subject to
the note above.
Note:
E-EQ-MX3MCPLUS-E
Firware Rev.
All
V1.01 or greater
V1.00
If the MX3X battery pack is inserted into a MX3 Multi-Charger Plus (without the V1.01
upgrade) bay , the battery may not become fully charged in the 4 hour time limit and a
red LED illuminates after 4 hours have elapsed indicating a Battery Problem.
Remove and reinsert the MX3X battery pack into the same charging bay. This will reset
the timer and allow the charger to complete the charge cycle for the battery in
approximately 2 hours..
LXE does not supply an external timing device with the Multi-Charger Plus. Contact
your LXE representative for charger upgrade details.
The MX3 Multi-Charger is obsolete.
Result
Properly charges MX3X or MX3-RFID battery. Also
for use with MX3Plus.
Properly charges MX3X or MX3-RFID battery.
Requires upgrade. See note below.
MX3 Multi-Charger
MX3A378CHGR6
(Not Available After July 2003)
Use LXE V1.20 Upgrade Kit
MX3 Multi-Charger Plus User's Guide
3