Table of Contents
Advertisement
Lenovo Moto E5
Level 2 – Service and Repair Manual
Rear-Facing Imager Removal
NOTE
The Rear-Facing Imager can be
recovered and reused after removal.
1.
Use the Tweezers to remove the Conductive
Cloth connecting the Rear-Facing Imager BtB
to the Heat Shield on the Main PCB.
NOTE
After you remove the Conductive
Cloth, you cannot reuse it.
2.
Use the Thin Plastic Spudger to disengage
the Rear-Facing Imager BtB Connector from
the Main PCB.
3.
Use your fingers to lift the Rear-Facing Imager
from the opening in the Main PCB.
PAGE 45
04/20/2018
Lenovo Confidential Restricted:
Do not share without consent from Lenovo
Advertisement
Table of Contents
