Removing and replacing an accelerator
Removing and replacing an accelerator
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel .
5. For full-lenght accelerators, release the expansion board retainers .
6. Remove the air baffle .
7. Disconnect the corresponding accelarator power cable.
Removing and replacing an accelerator
125