IBM E Server x336 Series Option Installation Manual page 35

Cover snaps
3. Install the Remote Supervisor Adapter II SlimLine cover:
a. Hook the four cover snaps on the right side of the cover to the adapter (the
side closest to the power-supply bay).
b. Rotate the adapter toward the cover and hook the left cover snaps to the
adapter.
Front mounting
bracket
4. The server comes with mounting brackets on the system board. There are front
and rear mounting brackets that hold the Remote Supervisor Adapter II SlimLine
in place. Align the locating pin on the adapter to the alignment hole on the rear
mounting bracket; then, slide the rear of the adapter underneath the flanges of
the rear mounting bracket.
5. Push the front of the adapter down onto the front mounting bracket. Push the
adapter down, until it snaps into place.
6. If you have other options to install or remove, do so now.
7. Go to "Completing the installation" on page 44.
Cover snaps
Remote Supervisor
Adapter II SlimLine assembly
Rear mounting
bracket
Remote Supervisor
Adapter II
SlimLine connector
Chapter 2. Installing options
23