IBM E Server x336 Series Option Installation Manual page 40

3. Rotate the two release-latches on the 3.5-inch hard drive cage up and then
4. Remove the left hard disk drive from the 3.5-inch hard drive cage.
5. Press the release latch on the left side of the DVD-ROM drive or DVD-ROM
6. Remove the retention clip from the DVD-ROM drive or DVD-ROM blank bezel.
28
IBM xSeries 336 Type 8837: Option Installation Guide
Release latches
forward to disconnect the electrical connectors and move the drive cage
forward; then, lift the 3.5-inch hard drive cage out of the server.
DVD-ROM drive
release latch
Release latch
blank bezel; then, pull the drive or blank bezel and attached retention clip out of
the drive cage.
This retention clip will be needed when you install a DVD-ROM drive or
DVD-ROM blank bezel in the hard drive cage.
DVD-ROM drive
DVD-ROM drive
retention clip