Table of Contents
Advertisement
Battery
5. Locate the battery (connector BH1) on the system board.
6. Remove the battery:
a. Use one finger to pull the retainer tab that secures the battery to its housing.
b. Use one finger to slide the battery up and out from its socket.
7. Insert the new battery:
a. Hold the battery so that the plus side of the battery is facing toward the
center of the server, toward slots 1 and 2.
b. Pull the retainer tab out of the way so that you can slide the battery into its
socket.
c. Slide the battery down until it snaps into place.
8. Reconnect the internal cables that you disconnected.
9. Reinstall the server cover, connect all cables and power cords, and set the
required configuration parameters (see "Completing the installation" on page
44).
Chapter 2. Installing options
43
Advertisement
Table of Contents
