Table of Contents
Advertisement
System-board jumpers
The following illustration shows the jumpers on the system board.
BIOS boot backup (J21)
Password reset (J22)
Force update BMC (J48)
Notes:
1. Before moving any jumpers, turn off the server; then, disconnect all power cords
2. Any system-board switch or jumper blocks that are not shown in the illustrations
and external cables. (Review the information in "Safety" on page iii, "Installation
guidelines" on page 13, "Handling static-sensitive devices" on page 14, and
"Turning off the server" on page 15.)
in this document are reserved.
5
Chapter 1. Introduction
Advertisement
Table of Contents
