Table of Contents
Advertisement
www.ti.com
5
Alternate Hardware Configurations
This section describes alternate hardware configurations in order to achieve better results or to more
closely mimic the system configuration.
5.1
Clocking Options
The default clocking mode uses the LMK04828 to generate the ADC sampling clock and FPGA clocks.
There are three additional clocking options that the EVM supports. These options are described in the
following sections.
5.1.1
External ADC Sampling Clock
An external clock can be used as the sampling clock for the ADC. This clock can be provided through a
transformer using the ADC CLK connector (J5). For this option, C65 and C73 need to be uninstalled and
installed at C64 and C72. The LMK04828 must still be used to provide the device clock to the TSW14J56
and the SYSREF signals to both boards. This option provides the best performance, as long as the clock
source has better phase-noise performance than the LMK04828. The source of the EXT ADC clock must
be synchronized with the LMK04828. To accomplish this, send the 10-MHz reference output from the
signal generator and connect it to J6 (LMK_CLKIN1) of the ADS54J69EVM. This causes LED D1 to
illuminate indicating the LMK VCXO source is locked to the external reference clock. The provided LMK
configuration files will work in this mode as well. If D1 does not illuminate, the signal from the outside
source may be to low. To correct for this, click on the LMK04828 tab at the top of the GUI. When the
LMK04828 page opens, click on the "PLL1 Configuration" tab. On the left middle side of the GUI, change
the Buffer Type of CLKin1 from "Bipolar" to "CMOS" as shown in
SLAU662B – January 2016 – Revised May 2016
Submit Documentation Feedback
Figure 8. GUI CMOS Selection
Copyright © 2016, Texas Instruments Incorporated
Alternate Hardware Configurations
Figure
8.
ADS54J69EVM
13
Advertisement
Table of Contents
