Troubleshooting; Maintenance - Black & Decker CWV9610SPT-B3 Instruction Manual

10 • ENGLISH
f Figure H: Remove the dust bowl by pressing the bowl
release button and pulling the bowl straight off.
f To replace the dust bowl, place it back onto
the handle until it "clicks" firmly into position.
f Figure I: While holding the dust bowl over
a wastebasket or sink, pull out the filter to empty
the contents of the bowl.
f Figure J: Empty the dust from the bowl and wash
if necessary.
f Figure K: The dust bowl can also be washed in warm
soapy water. Wash the filter regularly using warm,
soapy water and ensure that it is completely dry
before using it again. The cleaner the filter is,
the better the product will perform.
f Ensure that the dust bowl and filter is dry before
re-attaching.
f It is very important that the filter is correctly in
position before use.
Important! Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
Replacing the filters
The filters should be replaced every 6 to 9 months
and whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer:
f Remove the old filters as described above.
f Fit the new filters as described above.
BATTERY REMOVAL AND DISPOSAL
This product uses nickel-cadmium (Ni-Cd) rechargeable
and recyclable batteries. When the batteries no longer
hold a charge, they should be removed from the vac and
recycled. They must not be incinerated or composted.
To remove the battery pack for disposal:
1. First, before attempting to disassemble the product,
turn it on and leave it on until the motor completely
stops insuring a complete discharge of the batteries.
2. Using a phillips screwdriver, remove the seven screws
securing the two housing halves.
3. Lift the housing cover away from the assembly.
4. Detach all lead connections from the battery pack.
5. Remove battery pack and dispose of as per
ecommended guidelines.

MAINTENANCE

Bowls and filters can be washed thoroughly; however, use
only mild soap and a damp cloth to clean the main part of
the vacuum.
Important! To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment (other
than those listed in this manual) should be performed
by authorized service centers or other qualified service
personnel, always using identical replacement parts.

TROUBLESHOOTING

If the product does not work, follow the instructions below.
If this does not solve the problem, please contact your
local BLACK+DECKER repair agent.
f The charge indicator light is on when unit is connected
to charger.
f The charger was correctly plugged in for recharge.
(It feels slightly warm to the touch.)
f The charger cord is not damaged and is
correctly attached.
f The charger is plugged into a working electrical outlet.
f The switch is in the "OFF" position when charging.
ACCESSORIES
The performance of your tool depends on the accessory
used. BLACK+DECKER accessories are engineered
to high quality standards and designed to enhance
the performance of your tool. By using these accessories
you will get the very best from your tool.
Warning! The use of any accessory not recommended
for use with this product could be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical
products from the household, at municipal waste
sites or by the retailer when you purchase a new
product.