Black & Decker HSVB420J, HSVB520J - Powerseries 2-in-1 Cordless Stick Vacuum Cleaner & Hand Vac Manual
![]()
DEFINITIONS: SAFETY ALERT SYMBOLS AND WORDS
This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage.
![]()
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
![]()
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
![]()
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V | volts |
A | amperes |
Hz | hertz |
W | watts |
min | minutes |
![]() or AC | alternating current |
![]() or DC | direct current |
| no load speed |
| Class I Construction (grounded) |
| earthing terminal |
| safety alert symbol |
![]() | Class II Construction (double insulated) |
.../min or rpm. | revolutions or reciprocation per minute |
Wh | Watt Hours |
ASSEMBLY
![]()
Do not attempt to modify or repair the appliance.
Intended use
Your BLACK+DECKER lithium ion cordless 2 in 1 stick vacuum cleaner has been designed for light, dry vacuum cleaning purposes. This appliance is intended for household use only.
Assembly
![Black & Decker - Powerseries HSVB420J - Assembly Assembly]()
- Raise the handle
until it locks in place and twist the handle lock
to the locked position as shown in Fig. B - Insert the hand vacuum
into the stick vacuum chassis
as shown in Fig. C, ensuring it clicks firmly into place. - Align the bottom of the stick vacuum chassis
with the floor head
. - Push the bottom of the stick vacuum chassis
onto the floor head
so it locks into position as shown in Fig. C. - To remove an accessory, first remove the hand vacuum from the stick vacuum chassis.
- Pull the accessory from the stick vacuum chassis
. - To store an accessory, press the accessory into the stick vacuum chassis
.
![]()
When not in use position the unit with the rear of the vacuum facing a wall so that any inadvertent fall of the unit would contact a wall and not people or pets.
Charging the battery
![]()
For use only with the supplied charger.
From new, the rechargeable cells of the product need a minimum charge time of 5 hours to ensure full power.
- Ensure the hand vacuum is docked securely into the stick vacuum chassis.
![Black & Decker - Powerseries HSVB420J - Charging the battery Charging the battery]()
- Plug the jack plug
of the charger
into the charging port
located on the stick vacuum chassis. - Plug the charger into any standard 120 Volt 60 Hz electrical outlet.
- The LED
flashes RED during normal charge and turns GREEN for 60 seconds when the battery is fully charged. - Fast RED blink indicates a bad battery pack. Please contact your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
Battery discharging
- The LED
is GREEN when discharging. - The LED flashes GREEN when the battery charge is low.
- The LED flashes RED for 10 seconds when the battery is fully discharged.
- The LED flashes RED when the rotary brush is jammed or entangled. Please refer to section 'Removing and cleaning the rotary brushes'.
- Once the unit is fully discharged, the LED
will flash RED for 10 seconds every time the handvac or stick vac ON/OFF switch is pressed and the unit will not turn ON. - A charge cycle is required before the unit will turn ON.
- While charging, the charger may get warm, this is perfectly normal and safe. It is safe to leave the appliance connected to the charger indefinitely. The charger automatically reduces power consumption when charging is complete.
![]()
Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions.
Removing / Installing Hand Vac
![Black & Decker - Powerseries HSVB420J - Overview Overview]()
- Hand vacuum
- Hand vacuum ON/OFF button
- Hand vacuum release button
- Dust bowl
- Dust bowl release button
- Floor head
- Foldable handle
- Handle release
- Stick vacuum chassis
- Stick vacuum ON/OFF button
- Power Boost button
- Charging indicator light
- Charger
- Brush tool
- Crevice tool
To remove hand vac:
- Press the hand vacuum release button
. - Lift the hand vacuum
from the stick vacuum chassis
.
To install hand vac:
- Insert the hand vacuum
into the stick vacuum chassis
as shown in Fig. C, ensuring it clicks firmly into place.
Switching ON and OFF
Hand Vac Mode
- To switch ON, press the ON/OFF power button
. - To switch OFF, press the ON/OFF power button
.
NOTE: Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug.
Stick Vac Mode
- To switch ON, press the Stick vacuum ON/OFF button
. - For increased power, press the power boost button
.
NOTE: Pressing the power boost button more than once will cycle the power of the rotary brushes from normal to boosted. - To switch OFF, press the Stick vacuum ON/OFF button
.
NOTE: Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug.
Hand Vac Accessories
Your hand vacuum may be supplied with some of the following accessory:
![]()
- The brush tool
is designed for more effective cleaning of upholstered furniture and fabric. - The crevice tool
allows for vacuuming in narrow and hard to-reach places.
Fitting
- Insert the appropriate accessory into the front of the hand vacuum
as show in Figure E. - Make sure the accessory is fully pushed in. Fig. E
Dry pick up
For everyday spills of dry material.
- Do not fill the dust bowl
beyond the end of the intake chute.
Optimizing the suction force
In order to keep the suction force optimized, the filters must be cleaned regularly during use.
Emptying and Cleaning
Removing the dust bowl and filter
![]()
The filter is reusable and should be cleaned regularly.
![Black & Decker - Powerseries HSVB420J - Removing the dust bowl and filter Removing the dust bowl and filter]()
- Press the dust bowl release button
and pull the dust bowl
straight off as shown in Fig. F. - While holding the dust bowl over a trash can, pull out the filter assembly
to empty the contents. - Rotate filter
counterclockwise to unlock and remove it from the pre filter
. Gently remove any debris. - Reassemble the cleaned filter assembly and insert into the dust bowl.
- To replace the dust bowl, push it back onto the hand vacuum until it clicks firmly into place.
![]()
Never use the appliance without the filters. Optimum dust collection will only be achieved with a clean filter.
Cleaning the dust bowl and filter
The dust bowl
, pre filter
and filter
can be washed in warm soapy water.
- Make sure the pre filter
, filter
and the dust bowl
are completely dry before installing.
Removing and cleaning the rotary brushes
![Black & Decker - Powerseries HSVB420J - Removing and cleaning the rotary brushes Removing and cleaning the rotary brushes]()
![]()
To reduce the risk of injury from moving parts, disconnect the floor head from the vacuum before cleaning or servicing.
- To remove the rotary brush
, pinch and lift the plastic tab
on the pivoting clip
away from the floor head
. - Lift the rotary brush
out of the floor head. Clear the brushes of any hair or other debris that may have accumulated. - Replace rotary brush, and secure pivoting clip before using vacuum.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
- Remove the old filters as described in Cleaning the Filters.
- Fit the new filters as described in Cleaning the Filters.
(cat. no: SVF12)
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac; never immerse any part of the vacuum into a liquid.
![]()
Make sure the vacuum is completely dry before using it.
![]()
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.
TROUBLESHOOTING
If the product does not work, check the following:
- The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
- The charger cord is not damaged and is correctly attached.
- The charger is plugged into a working electrical outlet.
- The switch is in the "OFF" position when charging.
If vacuum performance is poor, check the following:
- Clean the filters. (See "Cleaning and emptying the vacuum" section.)
- Empty the dust bowl. (See "Cleaning and emptying the vacuum" section.)
- Clean the rotary brushes. (See "Removing and cleaning the rotary brushes" section.)
- The red LED flashes continuously, plug in the charger and perform a recharge cycle
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK+DECKER help line at 1–800–544–6986.
ACCESSORIES
Recommended accessories for use with your appliance are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986.
![]()
The use of any accessory not recommended for use with this appliance could be hazardous.
All BLACK+DECKER Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the BLACK+DECKER location nearest you. To find your local service location, call: 1-800-544-6986 or visit www.blackanddecker.com
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliances, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
![]()
Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury.
![]()
Some household dust contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm such as asbestos and lead in lead based paint.
![]()
Do not attempt to modify or repair the appliance.
![]()
Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase risk of fire.
![]()
To reduce the risk of fire, electrical shock or injury:
Shock Hazard. To protect against risk of electrical shock, do not put charging base in water or other liquid. - Do not allow to be used as a toy. Close attention is necessary when used by or near children.
- Use only as described in this manual. Use only manufacturer's recommended attachments.
- Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
- Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle charger, including charger plug, and charger terminals with wet hands.
- Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
- Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
- Use extra care when cleaning on stairs.
- Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Do not use without dust bag and/or filters in place.
- Do not charge the unit outdoors.
- Use only the charger supplied by the manufacturer to recharge.
- Do not incinerate the appliance even if it is severely damaged. The batteries can explode in a fire.
- This appliance is intended for household use only and not for commercial or industrial use.
- Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The unit should be placed or mounted away from sinks and hot surfaces.
- Plug the charger directly into an electrical outlet.
- Use the charger only in a standard electrical outlet (120V/60Hz).
- Unplug the charger from outlet before any routine cleaning or maintenance.
- Do not look into the air vents when the unit is switched on, as sometimes there is a possibility of small debris being discharged from the air vents, especially after cleaning / replacement of the filters as debris inside the unit can be disturbed.
- Leaks from battery cells can occur under extreme conditions. If the liquid, which is a 20-35% solution of potassium hydroxide, gets on the skin (1) wash quickly with soap and water or (2) neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek medical attention.
ADDITIONAL SAFETY WARNINGS
- Prevent unintentional starting. Ensure the switch is in the off-position before picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch on invites accidents.
- Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
- Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
- Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 266°F (130°C) may cause explosion.
- Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
- Only for use with HSVB420: JOD-S-180050A1 / BLJ15L180050P-U, HSVB520: JOD-S-220050A1 / BLJ15L220050P-U chargers.
BlackandDecker.com
1-800-544-6986
Imported by Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286
![]()
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need help?
Do you have a question about the Powerseries HSVB420J and is the answer not in the manual?
Questions and answers