Olsberg INARA 2.0 Installation Instructions Manual page 88

Pellet fireplace
Table of Contents

Advertisement

Available languages

Available languages

Operating manual
GB
for the user
Warnings
The ongoing combustion process is halted while there is a warning.
As long as the pellet fireplace is in
the combustion process, the warning is constantly visible. If a warn-
ing occurs while in standby, then the combustion process is not
permitted to start.
The warning is visible for 5 seconds every 30 seconds.
Display notification
Ext. requirement blocked
Outside the switching times
Flame temperature too warm
Room temperature too warm
Pellet cover open
Boiler temperature too warm
88
| 154
Cause of the fault
ū Connector not plugged in.
ū External room thermostat is not connected or is in-
correctly connected.
ū The temperature which has been set on the exter-
nal room thermostat is lower than the current room
temperature.
ū Active switching times are saved, and the current
time is outside the active switching times.
ū In "Automatic" operating mode, no night time reduc-
tion temperature is saved either.
ū The flame temperature is too high.
ū The current room temperature is too high (in
"Automatic" operating mode only).
ū Pellet reservoir cover open!
ū The water temperature in the pellet fireplace is too
high.
Possible remedy
● Plug the connector in!
● Connect the external room thermostat!
● Wait until the current room temperature has cooled
and the pellet fireplace starts automatically!
● Increase the desired temperature on the room
thermostat!
● Wait until the current time is within the active
switching times and the pellet fireplace starts
automatically!
● Define new switching times. Define a night time
reduction!
● Pellet fireplace can be started with the party
button.
● Wait until the flame temperature has cooled and
the pellet fireplace starts automatically!
● Wait until the current room temperature has cooled
and the pellet fireplace starts automatically!
● Increase the desired room temperature!
● Close the pellet reservoir cover!
● Wait until the current water temperature has cooled
and the pellet fireplace starts automatically!
We reserve the right to make technical changes
LEVANA 2.0 6 kW
LEVANA 2.0 8 kW
LEVANA AQUA 2.0
ARINA 2.0
INARA 2.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Levana aqua 2.0Levana 2.0 6/8 kwArina 2.0

Table of Contents