Olsberg INARA 2.0 Installation Instructions Manual page 75

Operating manual
GB
for the user
Warning! Risk of serious personal injury,
property damage and/or environmental damage!
● The pellet fireplace may only be fired with pellets which
comply with DIN EN 14961-2 and the DIN-plus certification
programme or the Austrian standard M 7135: Max. moisture
10%, max. diameter 6 mm, max. length 30 mm!
● Store pellets in a dry and dust-free location!
● Do not allow any materials other than the pellets specified
above to get into the burner trough! Burning other flamma-
ble materials or waste causes damage to the pellet fireplace
and results in invalidation of the warranty!
● Never use flammable liquids such as petrol, lamp oils simi-
lar to petrol, petroleum, firelighters, or similar liquids to kin-
dle or "reignite" a fire! And make sure that such liquids are
a sufficient distance away from the pellet fireplace during
operation!
● Pellets may never be manually placed into the burner
trough, with the following exceptions: during recommis-
sioning and if the reservoir runs empty, a handful of pellets
must be poured into the burner trough towards the ignit-
er. Otherwise, only the pellet duct will be filled within the
filling period in the start phase and only an insufficient 2-5
pellets will fall into the burner trough.
Fig. 3.6 Never use flammable liquids and maintain a sufficient distance
from flammable liquids
Fig. 3.7 Do not manually pour pellets into the burner trough except
during recommissioning and if the tank runs empty
We reserve the right to make technical changes
Attention! Damage to the surface of the coating!
The pellet fireplace is coated with a high-quality tempera-
ture-resistant coating which only reaches its final strength
after being heated for the first time.
● You therefore should not place anything on the tiled pel-
let fireplace or touch the surfaces as this may damage the
coating!
● Never place the pellet sack on the hood!
● Make sure that packaging does not touch the hot surfac-
es when pouring in pellets as the packaging residue can be-
come burned into the surface of the coating!
Fig. 3.8 Do not place the pellet sack on hot surfaces while filling
LEVANA 2.0 6 kW
LEVANA 2.0 8 kW
LEVANA AQUA 2.0
ARINA 2.0
INARA 2.0
75 | 154