Troubleshooting - York Fitness Atomic Owner's Manual

Troubleshooting

If you have a problem with your exercise equipment, before you do anything else please
check that all the cables have been connected correctly. Loose cables are very common
and many problems can be solved by making sure the cables are properly connected.
The following table details the most common problems and how to fix them. If you still have a problem
after going through the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM
NO DISPLAY
NO SPEED
DISPLAY
PARTIAL DISPLAY
NO PULSE
SIGNAL
FOR YOUR OWN SAFETY, DO NOT OPEN PROTECTIVE CASING. IF ERROR PERSIST,
PLEASE CONTACT YOUR LOCAL YORK DISTRIBUTOR FOR ADVICE. KEEP THE
EQUIPMENT OUT OF USE UNTIL IT IS REPAIRED.
If you are having problems with your heart rate reading, please note that some fibres used in
clothes eg) polyester, create static electricity that may prevent a reliable heart rate reading. Mobile
phones, TV's, microwaves and other electrical appliances that generate an electromagnetic field
may also interfere with heart rate measurement.
CAUSE
No power
Wires are damaged or not
connected properly
Speed sensor is too far from magnet Contact your local YORK distributor
The PA board is not connected
properly
Wires are damaged or not
connected properly
Too much hand movement
Palms too wet
Hand Pulse Sensor is being gripped
too tightly
User is wearing rings
www.yorkfitness.com
CORRECTION
Check batteries
Verify all wires are connected
properly
Verify all wires are connected
properly
Disconnect and re-connect all
cables
Contact your local YORK distributor
Verify all wires are connected
properly
Dry palms
Grip using moderate pressure
Remove all rings
Contact your local YORK distributor
13