Troubleshooting - York Fitness 53085 Owner's Manual

Troubleshooting

If you have a problem with your exercise equipment, before you do anything else please check that all the cables have
been connected correctly. Loose cables are very common and many problems can be solved by making sure the cables are
properly connected and not damaged.
The following table details the most common problems and how to fix them. If you still have a problem after going through
the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM
NO DISPLAY
NO SPEED DISPLAY
PARTIAL DISPLAY
NO PULSE SIGNAL
ERROR CODE: E1
ERROR CODE: E4
ERROR CODE: E5
For your own safety, do not open protective casing. If error persist, please contact your local york distributor for advice.
Keep the equipment out of use until it is repaired.
If you are having problems with your heart rate reading, please note that some fibres used in clothes eg) polyester, create
static electricity that may prevent a reliable heart rate reading. Mobile phones, TV's, microwaves and other electrical
appliances that generate an electromagnetic field may also interfere with heart rate measurement.
CAUSE
No power
System halted
Wires are damaged or not connected properly
Speed sensor is too far from magnet
The PA board is not connected properly
Wires are damaged or not connected properly
Too much hand movement
Palms too wet
Hand Pulse Sensor is being gripped too tightly
User is wearing rings
Hands are not hold on tightly on grips during BODY FAT test.
Check the user's age, height, weight figure setting when the test result is out of the range of FAT% 5~50
and BMI 5~50%.
Check the cable is well connected or connector broken.
www.yorkfitness.com
CORRECTION
Make sure power cord is plugged in properly
Unplug and re-plug the power cord to reset the
system
Verify all wires are connected properly
Contact your local YORK distributor
Unplug and re-plug the power cord
Verify all wires are connected properly
Disconnect and re-connect all cables
Contact your local YORK distributor
Verify all wires are connected properly
Grip firmly
Dry palms
Grip using moderate pressure
Remove all rings
13