Advertisement
2
FIT AND SECURE
2.1
Remove the canopie's roof rails if fitted. Determine the best possible position for mounting the tracks.
Take care not to drill into or through any reinforcements.
2.2
Measure and trim the tracks to the desired length.
2.3
Once you are happy with the placement of the track, mark all the holes using a suitable marking pen.
2.4
Drill a 4mm pilot hole on all the marks you have made. If you are using the M6 Nyloc nuts (Item 8) for
the fitment, open the pilot holes to 6.5mm. Always take care when drilling.
2.5
When using the Clinch Nuts (item 10) you will need a Clinch nut Tool to crimp and secure the Clinch
nuts.
2.6
Should any of the mount points be inaccessible to use nuts, open the hole to 9.5mm and use
the Clinch Nut (Item 10). ONLY TO BE USED WITH METAL CANOPY / CAPS AND TRAILER TOPS.
2.7
Apply a bead of suitable sealant to each hole drilled in step 2.4.
2.8
1
2
3
4
5
6
COMPLETION
3
Congratulations. You did it. Take a step back and admire your work!
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
4
Now's the time to visit your favorite Front Runner Dealer in person or Online.
TRCA005_REV_A03
Roof
10mm
7
8
4mm
9
3
© COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
Fit and secure the tracks with a
combination of Items 1/2, 6, 7, 8 & 10.
Depending on the thickness of the
material you are bolting through you can
use either M6x20 Button Head or M6x30
Button Head (Items 1 or 2). The bolt
needs to go through the
Nyloc Nut (Item 8).
Install the End-Caps and Protecive Trim
(Items 4 & 5) before you do the final
fitment of the tracks.
Check that all the fasteners are fully
tightened.
Place M6 nut caps (item 9) on all the M6
Nyloc Nuts (item 8) to finish of the
fitment .
Advertisement
