Operation Modes and the System Menu
3-3
Operation Modes and the System Menu
3-3-1
System Menu and the Operation Modes
Power ON
3-3-2
Menu Tree
84
The NT20 operates in either "RUN", "Transmit", or "Maintenance" mode. The
operation modes can be changed by using the System Menu.
Select an operation mode by pressing the corresponding touch switch in the
System Menu. The operation modes with respect to the System Menu are
related to each other as shown below.
For the operations with the System Menu, refer to the 3-3-3 Operations with
the System Menu (page 86).
RUN mode
The NT20 runs in this
state. Controls from the
Host are enabled and
various indications and
I/O operations are made.
When system
settings and screen
data registration have
been completed
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance mode
The System Menu allows to effect various NT20 functions by using the touch
switches. The NT20's functions with respect to the System Menu are related
as shown below.
For the operations with the System Menu, refer to the 3-3-3 Operations with
the System Menu (page 86).
To change system settings
or screen data contents
Section 3-3
Transmit mode
Screen data and other
data are transmitted
between the NT20 and a
support tool.
Maintenance mode
The NT20 maintenance
operations such as
memory initialize and
setting check are
executed.