Advertisement
LED STATUS AND TROUBLESHOOTING
The ignition control has a multi-colored (GREEN, ORANGE, and RED) LED which will
flash different colors and codes to show status of the ignition and will help troubleshoot
the control.
Table 3: GREEN LED Indications of Normal Operation
Flash
1 blink every 5 sec.
1 blink every 1 sec.
rapid blinking
on solid
Table 4: ORANGE LED Indications
Flash
1 blink every 5 sec.
1 blink every 1 sec.
1 blink every 1 sec.
Table 5: RED LED Indications of ERROR Codes (100% Lockout)
Flash
1 blink
2 blinks
3 blinks
4 blinks
5 blinks
6 blinks
7 blinks
8 or 9 blinks
on solid
Note: There is a one-second pause after each flash code.
Warning: Do not install the control in areas that can be exposed to dripping water,
steam cleaning, heavy dust, grease, or corrosive chemicals. If the controls can be
subjected to this type of environment, use a NEMA 4 rated enclosure to protect the
ignition control module.
If not properly protected from the above environment, the control will prematurely fail or
malfunction. Excessive high temperatures can damage the ignition control and cause
it to malfunction. Make sure the ambient temperature around the ignition does not
exceed the rated temperature for the control.
©
2018 BASO Gas Products
Part No. BASO-INS-C610UQRG, Rev. C
Indication
Waiting for "Call for Heat"
Pre-purge, Inter-purge, Post-purge
Trial for Ignition (TFI)
RUN (Flame, Pilot/Main valves on)
Indication
Retry
Flame Present
Pressure Present
Indication
No flame in trial time
Flame sense stuck
Pilot relay circuit
MV relay circuit
Rollout
Pressure switch
Repetitive flame loss
Internal control
Line voltage/Frequency
24 VAC Universal Intermittent Pilot Gas Ignition Control
Error Type
Standby
Standby
Standby
Error Type
100% Lockout
100% Lockout
100% Lockout
100% Lockout
100% Lockout
100% Lockout
100% Lockout
100% Lockout
Standby
www.baso.com
6
Advertisement
