Advertisement
FLAME CURRENT MEASUREMENT
Flame current of the device can be measured using a standard
microammeter by simply touching the meter leads to the 2 PIN labeled FC,
as shown in Figure 2.
Flame current must be measured with pilot valve lit but no
main gas flowing.
Set meter to DC μAmp scale.
Make sure meter leads are positioned correctly [+/-].
Typical Pilot Only Flame Sense Current of 0.4 to 1.0 μAmp DC
Important: Preventative maintenance programs are an important part of maintaining
optimum and safe function of you BASO Products. For more maintenance information,
refer to the "Setup and Adjustements" sectin of the complete installation instructions. Any
attempt to repair this assembly voids the manufacturer's 2 year warranty. For a
replacement control, contact the original equipment manufacturer or nearest BASO Gas
Products distributer.
450 East Horseshoe Road
PO Box 170
Watertown, WI 53094
1-877-227-6427 (1-877-BASOGAS)
©
2018 BASO Gas Products
Part No. BASO-INS-C610UQRG, Rev. C
BLACK
(-)
Figure 2: Microammeter Connection
24 VAC Universal Intermittent Pilot Gas Ignition Control
RED (+)
.
www.baso.com
Published in U.S.A.
8
www.baso.com
Advertisement
