Advertisement
(6) 1) Remove the screw, slide the service cover (control box) to the arrow direction, and then remove.
(Refer to Fig. 8)
2) Remove the tape for transportation (4 places) of the service cover (control box).
1) Screw
4. INSTALLATION OF DECORATION PANEL
• For installation of the indoor unit, refer to the installation manual attached to the indoor unit.
(1) Install the decoration panel
1) Tighten 2 screws for installing decoration panel at the position of indoor unit shown Fig. 9 temporarily.
(For temporal tightening, tighten about 10mm)
2) Adjust so that the lead wiring side of the decoration panel contacts the piping side of the indoor unit.
At that time, be careful not to have the connector of the swing motor lead wiring get caught between the
decoration panel and the indoor unit.
English
1) Service cover
(control box)
Fig. 8
2) Tape for
transportation
2) Tape for
transportation
4
Advertisement
