Advertisement
2) Make sure to connect the connector of the swing motor lead wiring to the connector on the Printed Cir-
cuit Board (A1P) inside of the indoor unit control box. (Refer to Fig. 22)
Control box lid
Let the connector of the
lead wiring into the control
box lid and the control box.
Printed Circuit Board (A1P)
3) After finishing wiring, close the resin cover as it was. (Clamps are not needed.) (Refer to Fig. 21)
5. INSTALLATION OF SERVICE COVER (CONTROL BOX) AND AIR FILTER
(1) Attach the service cover (control box). (Refer to Fig. 23)
After hooking the front tab, tighten by the screw. (Refer to Fig. 24)
Screw
Fig. 23
(2) Hook the part of air filter to the tab of the decoration panel. (Refer to Fig. 25)
English
Service cover
Front tab
Wire saddle
Let the lead wiring
into the wire saddle.
Swing motor lead wiring
Connector (X36A)
Fig. 22
Service cover (conrtol box)
Screw
Fig. 24
2) Connect firmly
10
Advertisement
