Functions And Features; Installation - IFM RM 3 Series Operating Instructions Manual

• Installation, electrical connection, set-up, programming, configuration, operation
and maintenance of the product must be carried out by personnel qualified and
authorised for the respective activity�
• Protect units and cables against damage�

3 Functions and features

The encoder converts rotary movements into digital numerical values� Each
angular position of the revolutions is provided as a numerical value�
These values allow angular movements to be measured and positions to be
determined�
Because of the requirements for electromagnetic interference emissions, the
device is intended for use in industrial environments� The device is not suitable for
use in domestic areas�

4 Installation

► Disconnect power�
► Ensure that the machine stands still�
► The drive must not be started during installation�
► Do not hit the shaft; do not use a file or similar tool on the shaft: risk of
destruction�
► Keep potential interfering sources (magnets, heat sources etc.) at a distance.
This product is a precision measuring device� Therefore it has to be handled with
care by trained staff� The following warnings apply to influences outside the limit
values indicated in the product data sheet�
Damage to the product can be caused by:
• too high forces on the shaft
• humidity and chemical liquids (do not connect any cables oriented upwards)
• extreme temperatures
• too high vibrations and shocks
• short circuit or too high an operating voltage
• impact, shock or any other physical forces
4