Necessary Procedure After Battery Change - Seiko SPC167P1 Instructions Manual

Table of Contents

Advertisement

WARNING
l Do not remove the battery from the watch.
l If it is necessary to take out the battery, keep it out of the reach of children. If a
child swallows it, consult a doctor immediately.
CAUTION
l Never short-circuit, tamper with or heat the battery, and never expose it to fire.
The battery may burst, become very hot or catch fire.
l The battery is not rechargeable. Never attempt to recharge it, as this may
cause battery leakage or damage to the battery.
22
NECESSARY PROCEDURE AFTER BATTERY
CHANGE
After the battery is replaced with a new one, or when an abnormal display appears,
follow the procedures below to reset the built-in IC. The watch will resume its
normal operation.
l HOW TO RESET THE IC
1. Pull out the crown to the second click.
2. Press button A and B at the same time for 2 seconds or longer.
. Push the crown back in to normal position and check if the small second
hand moves as normal.
* Resetting the IC will initialize the watch. Before starting to use the watch, it will be necessary to set
the time and adjust the STOPWATCH hands to the 0 position. Refer to "SETTING THE TIME AND
ADJUSTING THE STOPWATCH HAND POSITION" section of this manual.
A
CROWN
B
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

7t85Spc165p1Spc167p2Spc168p1Spc163p1Spc163p2

Table of Contents