Advertisement
SPECIFICATIONS
●
Measurement functions
Accumulated elapsed time measurement and split time measurement are available.
● Standard measurement
Button
START
● Accumulated elapsed time measurement
Button
START
Restart and stop of the stopwatch can be repeated by pressing b utton
● Split (intermediate) time measurement
Button
START
Measurement and release of the split time can be repeated by pr essing button
● Measurement of two competitors
Button
START
NECESSARY PROCEDURE AFTER BATTERY CHANGE
After installing the battery, pull out the crown to the second click position. And then follow the
instructions below to correct the hand positions and set the time.
Crown
Crown
Button A
Button A
Button B
Button A
Button B
Crown
Push back in to the normal position in accordance with a time signal.
Note*
Pressing Button A for longer than 2 seconds here will allow you to resume the procedure again
A
Button
A
Button
→
→
STOP
RESET
A
Button
A
Button
→
→
STOP
RESTART
A
Button
B
→
→
SPLIT
Button
B
A
→
FINISH TIME OF FIRST
RUNNER
Pull out to the click position when the small second hand is at the
60 seconds position. The small second hand stops on the spot.
Turn to set the main time.
Press Button A for longer than 2 seconds to ready for "0" position adjustment.
Press Button A for longer than 2 seconds.
The STOPWATCH second hand turns a full circle.
Press Button B to set the STOPWATCH second hand to the "0" position.
Press Button A for longer than 2 seconds.
The STOPWATCH hour and minute hand turns a full circle.
Press Button B repeatedly to reset the STOPWATCH
position. (12:00) It moves quickly
second hand to the "0"
if button B is kept pressed.
B
A
Button
A
... →
STOP
A
Button
B
Button
→
SPLIT RELEASE
STOP
Button
A
→
→
SECOND RUNNER
FINISH
* Check that AM/PM is correctly set.
/18
3
Button
B
→
RESET
.
Button
B
A
→
RESET
B
.
Button
B
Button
→
FINISH TIME OF
RESET
SECOND RUNNER
Note*
Cal. 7T11A
B
Advertisement
