Advertisement
REMARKS ON REPAIRING CAL. 7T82A
II. NECESSARY PROCEDURE AFTER BATTERY CHANGE
After installing the battery, reset the built-in integrated circuit, and then set the time and reset
the STOPWATCH hands to the "0" position following the procedure below.
Crown
Crown
Systen Reset
Button A
Button B
Button A
Button B
Button A
Button B
Crown
Note*
Pressing Button A for longer than 2 seconds here will allow you to resume the procedure again
as indicated by the arrow if neccessary.
Pull out to the 2nd click when the small second hand is at the
12 o' clock position.
Turn to set the main time.
* Check that AM/PM is correctly set.
Pull out the crown to the 2nd click.
Press and hold both buttons A and B at the same time for longer than 2 seconds.
Press Button A for longer than 2 seconds.
The STOPWATCH 1/100 second hand turns a full circle.
Press Button B to set the STOPWATCH
1/100 second hand to the "0" position.
Press Button A for longer than 2 seconds.
The STOPWATCH second hand turns a full circle.
Press Button B to set the STOPWATCH
second hand to the "0" position.
Press Button A for longer than 2 seconds.
The STOPWATCH minute hand turns a full circle.
Press Button B to set the STOPWATCH minute hand to
the "0" position.
Push back in to the normal position in accordance with a time signal.
/26
Note*
Advertisement
