Table of Contents
Advertisement
TROUBLESHOOTING
Trouble
The watch stops operating.
The small second hand moves in 2-second
increments.
The watch temporarily gains or loses
time.
The STOPWATCH hands do not return to
the "0" position when the stopwatch is reset.
The inner surface of the glass is clouded.
The date changes at 12 o'clock noon.
2
Possible causes
The battery has run down.
The battery nears its end.
The watch has been left or worn in extremely
high or low temperatures.
The watch has been left close to an object with a
strong magnetic field.
You drop the watch, hit it against a hard surface,
or wear it while playing active sports. The watch
is exposed to strong vibrations.
The watch has been affected by magnetism or
exposed to strong shocks or vibrations.
Moisture has entered the watch because the
gasket has deteriorated.
AM/PM is not properly set.
Solutions
Have the battery replaced with a new one immediately by the retailer from whom the watch was
purchased.
Return the watch to a normal temperature so that it works accurately as usual, and then reset the
time. The watch has been adjusted so that it works accurately when it is worn on your wrist
under a normal temperature range between 5 ºC and 5 ºC.
Correct this condition by moving and keeping the watch away from the magnetic source. If this
action does not correct the condition, contact the retailer from whom the watch was purchased.
Reset the time. If the watch does not return to its normal accuracy after resetting the time,
contact the retailer from whom the watch was purchased.
Adjust the STOPWATCH hands to the "0" position by following the instructions in "SETTING THE TIME AND
ADJUSTING THE STOPWATCH HAND POSITION".
Contact the retailer from whom the watch was purchased.
Advance the hour hands for 12 hours to correctly set the time and date.
* In the event of any other problem, please contact the retailer from whom the
watch was purchased.
25
Advertisement
Table of Contents
