Table of Contents
Advertisement
SPECIFICATIONS
NECESSARY PROCEDURE AFTER BATTERY CHANGE
After installing the battery, pull out the crown to the second click position. And then follow the
instructions below to correct the hand positions and set the time.
1. Main time setting
Crown
Crown
2. Resetting the circuit
Pull out the crown to the 2nd click.
Press and hold both buttons A and B at the same time for longer than 2 seconds.
3. Resetting stopwatch hands to "0" positions
Button A
Button B
Button A
Button B
Button A
Button B
Crown
Note*
Pressing Button A for longer than 2 seconds here will allow you to resume the procedure again
as indicated by the arrow if neccessary.
Pull out to the 2nd click when the small second hand is at the
12 o' clock position.
Turn to set the main time.
* Check that AM/PM is correctly set.
Press Button A for longer than 2 seconds.
The STOPWATCH 1-minute hand turns a full circle.
Press Button B to set the STOPWATCH 1-minute hand
to the "0" position.
Press Button A for longer than 2 seconds.
The STOPWATCH 1/5 second hand turns a full circle.
Press Button B to set the STOPWATCH
1/5 second hand to the "0" position.
Press Button A for longer than 2 seconds.
The STOPWATCH 10-minute hand turns a full circle.
Press Button B to set the STOPWATCH 10-minute hand to
the "0" position.
Push back in to the normal position in accordance with a time signal.
3/7
Note*
Advertisement
Table of Contents
