Schwinn 190 Service Manual page 61

5. Using a #2 Phillips Screwdriver, remove the 10 screws
(b) that secure the Left Shroud. Remove the bottom screws
Note: It is not necessary to remove the Crank Arm and
Crank Disc in order to remove the Shroud. Turn
the Crank Arm to point up toward the front of the
bike.
Carefully angle and remove the Left Main Shroud. Remove
the Bolt Catch Insert at the base of the Seat Post. Set the
parts safely aside for reassembly.
If you are replacing the Servo/Sensors cable assembly (wiring har-
ness), continue to step 6.
If you are not replacing the Servo/Sensors cable assembly (wiring
harness), go to step 8.
6.
Using a #2 Phillips Screwdriver, remove 3 screws (a)
that attach the Crank Disc to the Right Main Shroud. Set
them safely aside for reassembly.
Left side (Top shroud and pedal not shown for clarity)
b
Bolt catch insert Bolt catch insert
Right side (Top shroud and pedal not shown for clarity)
disc
Main
shroud
61
b
a
b