Table of Contents
Advertisement
Field Name
Description
Enable WMF
Select to enable Wireless Multicast Forwarding (WMF).
Enable HSPOT
Select to enable Hotspot 2.0 access.
Max Clients
Enter the maximum number of clients that can connect to this access point.
BSSID
Displays the Basic Service Set Identifier or "N/A".
Security
On this page, you can configure network security settings of a wireless LAN interface, either by using the WiFi Protected Setup (WPS)
method or by setting the network authentication mode. For WiFi Protected Setup, the following methods are supported:
PIN entry, a mandatory method of setup for all WPS-certified devices. Options are:
l
Enter STA
PIN: You must enter the (input) station PIN from the client.
l
Use AP
PIN: AP generates the device PIN.
l
PBC (Push button configuration): Uses a simulated push button in the software. (This is an optional method on wireless cli-
l
ents.)
To use the PIN method, you need a Registrar (access point/wireless gateway) to initiate the registration between a new device and
an active access point/wireless gateway.
Note: The PBC method may also need a Registrar when the PIN is all zeros.
Seven types of network authentication modes are supported: Open, Shared, 802.1X, WPA2, WPA2-PSK, Mixed WPA2/WPA, and Mixed
WPA2/WPA-PSK.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
111
Advertisement
Table of Contents
