Collecting Access Logs - Assa Abloy Zi IKON CLIQ Go Manual

The key (K1) is now blocked from access to all cylinders.
See also Section
5.5.3

Collecting Access Logs

To view an access log, it has to be collected from the cylinder. Figure 9
Logs in Three Steps
Figure 9. Collecting Access Logs in Three Steps
1) Create collecting task in the system and transfer it to a key (K2).
a)
b)
c)
d)
e)
f)
g)
h)
2) Get the access log into the key (K2) from the cylinder.
a)
b)
44
If the key is declared blocked but still has access to one or more cylinders, it
will be displayed in red under Blocked with access. Carry out all blocking
tasks in order to block the key from access.
5.6.6 "Blocked Keys", page 46.
", page 44 shows three basic steps to collect the access log.
Select the cylinder to collect access logs.
Click Access log.
Events from previously collected access logs are displayed.
Click Request access log.
A task to collect the access log from the cylinder is created.
Click Task list to view all tasks that are not yet carried out.
Check the task for the applicable cylinder.
Click Assign selection to a key.
Select a key to use for collecting the access log and click Save.
Insert the key into the programming device to transfer the task to the key.
If the key is Connect key, start CLIQ™ Connect app. The task is transferred
directly to the key via Bluetooth connection from the mobile phone.
Any key in the system can be used as long as it is not blocked by the
cylinder.
... ...
Go to the cylinder.
Insert the key into the cylinder.
"Collecting Access
..
5 CLIQ™ Go Locking Systems