System Options; Set Options Using The Mode And Sel Buttons - PairGain HiGain HLU-319 Manual

150-319-142-01

System Options

The HLU-319 List 4B contains non-volatile RAM (NVRAM) that stores the
system settings options. No dip-switches or jumpers are required to configure
the system options. They are set using the MODE and SEL buttons on the
front panel, through an dumb terminal connected to the Craft (RS-232) port,
or from a Network Management interface. The System Settings are retained
if shelf power is lost or if the HLU-319 List 4B is unplugged.

Set Options Using the MODE and SEL Buttons

To provision the HLU-319 List 4B using the front panel MODE and SEL
buttons:
1 Press the MODE button at least for one second, but less than three
seconds, and release. The message on the front panel display alternates
between the first system parameter and its current setting.
2 Press the SEL button repeatedly to scroll through all possible parameters
of the option being displayed.
3 After selecting the desired option, press the MODE button. This updates
the current displayed mode to the setting selected, then selects the next
configurable parameter.
After the last option is selected, the following
Confirm? (Yes/No)
message appears in the front panel display:
CONF NO
4 Do one of the following:
•
Cancel the session without saving the requested parameter changes
by pressing the MODE button. (The display also returns to its
normal mode, without installing any new changes, if neither button
is pressed for 30 seconds.)
•
Accept the requested parameter changes by pressing the SEL button.
Yes displays and the changes are made.
The display returns to its normal mode.
HLU-319 List 4B
December 22, 1997
PairGain Engineering - Plant Series
Revision 01
21