Subscribe to Our Youtube Channel
Related Manuals for Briggs & Stratton R020798
Summary of Contents for Briggs & Stratton R020798
- Page 1 Reconditioned Pressure Washer Operator’s Manual R020798 R020816 Copyright © 2021. Briggs & Stratton Milwaukee, WI, USA. All rights reserved. Manual No. 80104264 Rev B (800) 743-4115...
-
Page 2: Table Of Contents
Table of Contents Symbol Name Explanation Symbols and Meanings ......2 High-pressure water could cut Fluid through skin resulting in serious Assembly. -
Page 3: Assembly
Assembly Handle and Accessory Tray Attachment... -
Page 4: Equipment Description
Equipment Description Stay alert—watch what you are doing. Do not operate pressure washer when fatigued or under the influence of alcohol or drugs. Read this manual carefully and become familiar Every effort has been made to ensure that information in with your product. -
Page 5: Features And Controls
Features and Controls Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and product warnings. - Page 6 Spray Gun 7-in-1 Nozzle Spray Wand Low Oil Shutdown Automatic Cool Down Engine Switch System (on pump) Detergent Tank Automatic Cool Down System — Prevents internal pump Spray Wand — Allows you to switch between 7-in-1 nozzle damage by discharging warm water to the ground. and optional accessories.
-
Page 7: Operation
Operation WARNING! Engine exhaust contains carbon monoxide, a poisonous gas that could kill you in minutes. You cannot smell it, see it, or taste it. Step 1: Safe Location Even if you do not smell exhaust fumes, you could still be Before starting the pressure washer, there are two equally exposed to carbon monoxide gas. - Page 8 Step 2: Oil and Fuel Operation Location to Reduce the Risk of Fire WARNING! Exhaust heat/gases could ignite Check Oil Level combustibles, structures or damage fuel tank CAUTION! Avoid prolonged or repeated skin causing a fire, resulting in death or serious injury. contact with used motor oil.
- Page 9 1. Slowly remove fuel cap to relieve pressure in tank. Check / Connect Gun and Hose 2. Slowly add fuel to fuel tank. Do not fill above bottom of 1. If spray gun trigger depresses without pressing fuel tank neck to allow for fuel expansion. trigger lock or if spray gun remains depressed when released, replace spray gun immediately.
- Page 10 Step 5: Start Up 3. Turn on water, point spray gun in safe direction, press trigger lock and depress trigger to purge pump system NOTICE Do not start engine without water supply of air. connected and turned on. 4. Attach spray wand to spray gun. Tighten by hand. 1.
- Page 11 Usage Tips 7. When engine starts, move choke lever to RUN ( ) position. • For most effective cleaning when in high pressure, keep 7-in-1 nozzle 8 to 24 in (20 to 61 cm) away from NOTICE If engine starts but fails to run, see Low Oil cleaning surface.
-
Page 12: Maintenance
Maintenance Detergent Siphoning Check Ball The check ball in detergent siphoning system may become Maintenance Schedule stuck from dried soap or minerals in water. The check ball can be freed by performing the following: Follow the hourly or calendar intervals, whichever occurs first. - Page 13 Add Engine Oil Fastener Cover Fastener 1. Place pressure washer on level surface. Filter 2. Clean area around oil fill and remove yellow oil fill cap/ dipstick. 3. Slowly pour oil into oil fill opening. Checking oil level frequently, fill to Full mark on dipstick. Stud Full Seal Washer...
-
Page 14: Storage
Common Service Parts Protecting the Pressure Washer 4. Turn off water and purge system. Pump Saver™ ......6039 5. -
Page 15: Troubleshooting
Troubleshooting Problem Cause Correction 1. Inadequate water supply. 1. Provide adequate water flow. Pump has following 2. Clogged inlet hose screen. 2. Check and clean inlet hose screen. problems: failure to 3. 7-in-1 nozzle is obstructed. 3. Clean nozzles. See 7-in-1 Nozzle produce pressure, loss Maintenance. -
Page 16: Warranty
BRIGGS & STRATTON RECONDITIONED PRODUCTS WARRANTY POLICY January 2014 LIMITED WARRANTY Briggs & Stratton warrants that, during the warranty period specified below, it will repair or replace, free of charge, any part that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below.
Need help?
Do you have a question about the R020798 and is the answer not in the manual?
Questions and answers