Daikin Emura 3 Series Service Manual page 22

3 | Troubleshooting
3.5.12 E6-00 – Outdoor unit: Compressor startup defect
Service manual
22
draft – 22/04/2022 08:50
INFORMATION
If all procedures listed above have been performed and the problem is still present,
contact the helpdesk.
Trigger
The motor rotor does
NOT rotate when the
compressor is energized.
To solve the error code
INFORMATION
It is recommended to perform the checks in the listed order.
1 Perform a check of the discharge pipe thermistor. See Thermistors.
Possible cause: Faulty discharge pipe thermistor or connector fault.
2 Check that all stop valves of the refrigerant circuit are open. See
"5.2 Refrigerant circuit" [
Possible cause: Closed stop valve in the refrigerant circuit.
3 Check if the refrigerant circuit is clogged. See
Possible cause: Clogged refrigerant circuit.
4 Check if the refrigerant circuit is correctly charged. See
4
circuit" [ 62].
Possible cause: Refrigerant overcharge or shortage.
5 Check for the presence of non‑condensables and/or humidity in the
refrigerant circuit. See
Possible cause: Non‑condensables and/or humidity in the refrigerant circuit.
6 Perform a check of the compressor. See Compressor.
Possible cause: Faulty compressor or miswiring of the compressor power
supply cable.
7 Perform a check of the main PCB. See Main PCB.
Possible cause: Faulty main PCB.
8 Perform a check of the 4‑way valve. See 4-way valve.
Possible cause: Faulty 4‑way valve.
9 Perform a check of the expansion valve. See Expansion valve.
Possible cause: Faulty expansion valve.
INFORMATION
If all procedures listed above have been performed and the problem is still present,
contact the helpdesk.
Effect
Unit will NOT stop
operating.
Unit will stop operating
4
62].
"5.2 Refrigerant
"5.2 Refrigerant circuit" [ 4
Reset
Automatic reset after a
continuous run for
10 minutes.
Manual reset via user
interface.
4
circuit" [ 62].
"5.2 Refrigerant
62].
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04 – 2022.04