Daikin Emura 3 Series Service Manual page 59

To re-install the front grille
To re-install the front panel
To close the front panel
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04 – 2022.04
4 Install the heat exchanger thermistor in its holder.
5 Attach the wiring harnesses to the switch box as needed.
6 Connect the grounding wire to the heat exchanger using the screw.
7 Connect the power supply wiring to the power supply terminal X1M.
8 Install the power supply wiring bracket. Install and tighten the screw.
1 Install the front grille and firmly engage the 3 upper hooks.
2 Tighten the 2 screws and put the 2 screw covers back.
3 Re-install the flap.
4 Insert the wire harness back into the connector and secure it with the wire
clamp.
5 Close the front panel, see
1 Attach the front panel.
2 Align the shaft on right side with the shaft slot and insert it all the way in.
3 Push lightly the front panel to the right side, align the shaft on the left side
with slot and insert it all the way in.
4 Close the locks on both sides.
1 Set the filters as they were.
2 Lift the front panel slightly and remove the support from the fixing tab.
a Backside of the front panel
b Fixing tab
c Support
3 Close the front panel.
4 Gently press the front panel down until it clicks.
4
"4.1 Plate work" [ 48].
a
c
d
draft – 22/04/2022 08:50
4 | Components
Service manual
59