Daikin Emura 3 Series Service Manual page 55

To remove the front grille
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04 – 2022.04
a
a Arm
b Shaft slot
c Shaft
5 Remove the front panel.
6 To re-install the front panel, perform the steps in the opposite order.
CAUTION
Wear adequate personal protective equipment (protective gloves, safety glasses,...)
when installing, maintaining or servicing the system.
1 Open the front panel. See
2 Remove the service cover. See
3 Remove the wire harness from the wire clamp, disconnect the connector and
place it in the connector holder.
4 Position the flap carefully by hand, so it does not to get caught during front
grille removal.
5 If already installed, remove the 2 screw covers using a long flat plate such as a
ruler wrapped in a cloth and remove 2 screws.
a Connector
b Wire clamp
6 Push the front grille up and then towards the mounting plate to remove the
front grille from the 3 hooks.
b c
4
"4.1 Plate work" [ 48].
4
"4.1 Plate work" [
draft – 22/04/2022 08:50
4 | Components
48].
a
b
a
Service manual
55