Furniture of America CM7060GY-CK Assembly Instructions Manual

Furniture of America CM7060GY-CK Assembly Instructions Manual

Advertisement

Assembly Instructions
CM7060GY-CK/EK
ASSEMBLY RATING
Tools Required for Assembly:
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
Allen Wrench
(Included)
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
DIFFICULT
EASY
2 PERSONS RECOMMENDED
Page 1 of 6
Rev.14-03-19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM7060GY-CK and is the answer not in the manual?

Questions and answers

Summary of Contents for Furniture of America CM7060GY-CK

  • Page 1 Assembly Instructions CM7060GY-CK/EK ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench (Included) assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
  • Page 2 Page 2 of 6...
  • Page 3 Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed. Parts List Hardware List Due to the size and/or weight of this product, it is highly recommended that the assembly should be done near the area of its intended location.
  • Page 4 Align the foot (#5) onto the pre-drilled holes on the bottom corner of the headboard (#1). Prepare two bolt assemblies by inserting FIRST the lock washer (#E) Step 1 onto the bolt (#C) and then the flat washer (#D) onto the SAME bolt (#C), in that order.
  • Page 5 Align the two slat support legs (#7) with the pre-drilled holes of the central support rail (#4). Prepare 2 bolt assemblies by inserting FIRST Step 3 the lock washer (#E) onto the bolt (#B) and then the flat washer (#D) onto the SAME bolt (#B), in that order.
  • Page 6 Prepare a complete bed slat by using 3 slats (#6), two Step 5 center plastic connectors (#F) and two end caps (#G). See diagram below for the correct sequence in connecting those parts. Align the end caps (#G) with the pre-drilled holes on each side of the side rails (#2) and snap both ends to lock in place.

This manual is also suitable for:

Cm7060gy-ek

Table of Contents