TVS RAIDER Owner's Manual page 82

FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main causes for fuse failure.
Follow the procedure given below for inspecting and
replacing the fuse.
1. Open the cover frame L as explained earlier (refer
page no. 61).
2. The fuse case fitted near the battery contains
one 15A fuse, and two 7 .5A fuse. Each fuse is
provided with a spare.
3. Take out the fuse case from the battery band and
open its cover. Pull out the required fuse.
76
4. Inspect the fuse for failure. If found blown, replace
it with new one with the same rating (additional
fuses are provided inside the fuse case itself).
5. Close the fuse case and re-fix case into the
battery band.
6. Turn 'ON' the ignition switch and check for proper
functioning of electrical systems. Incase the
fuse fails again, consult the nearest TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
Caution
Do not use vehicle by shorting the wires without
fuse. This may result in overheating of electrical items /
wiring and may result in fire.
Do not use fuse of higher amperage than specified for
the safety of electrical system.