TVS RAIDER Owner's Manual page 67

COVER FRAME L
To access the battery assembly and the fuse, cover
frame L need to be removed. Follow the procedure
given below for removing and re-fixing cover frame.
For removing :
1. Remove the mounting screws (A & B) from the
cover frame mounting.
2. Loosen the snap revet screws and pull out the
snap rivets from the location (C,D & E).
3. Take out the cover frame by gently pulling it out
at front top end and rear end of the cover frame.
B
C
D
E
A
For reassembling:
1. Locate the lugs of the cover frame to the holes
provided in the fuel tank assembly and the frame
while ensuring the availability of the cushion in
the holes.
2. Gently press the cover frame lugs into the holes.
3. Install the mounting screws ( A & B) and the snap
revets (C,D & E).
4. While ensuring the proper seating of cover.
Note
Care should be taken not to damage the cover frame and
its lugs during removal and reassembly.
While re-fixing the cover frame, ensure the availability of
rubber cushion in the fuel tank hole.
61