During Use - A&D MX-50 Instruction Manual

Compliance with FCC rules
Please note that this equipment generates, uses and can radiate radio frequency energy. This equipment
has been tested and has been found to comply with the limits of a Class A computing device pursuant to
Subpart J of Part 15 of FCC rules. These rules are designed to provide reasonable protection against
interference when this equipment is operated in a commercial environment. If this unit is operated in a
residential area, it may cause some interference and under these circumstances the user would be
required to take, at his own expense, whatever measures are necessary to eliminate the interference.
(FCC = Federal Communications Commission in the U.S.A.)
Compliance with Council Directives
This device features radio interference suppression and safety regulation in compliance with the
following Council Directives
Council directive 89/336/EEC
Council directive 73/23/EEC
P r e c a u t i o n s
2

2.1. During Use

For Safe Measurement
Operate the analyser using the following procedure.
• Place the sample pan in the correct position.
• Hold the handle of the heater cover to open or close.
• Use the sample pan handle to move the sample pan.
• The glass-housing becomes very hot,do not touch until cool.
• The sample pan and pan handle can get very hot at the end of a
test, allow them to cool before handling.
• Use the tweezers or spoon to move the sample.
GB 4
EN61326 EMC directive
EN61010-1 Low voltage directive
AND MX-50/MF-50 Instruction Manual
Heater cover
handle
Sample pan
handle
Glass-
housing
Sample
pan
Breeze
break ring