Table of Contents
Advertisement
Chapter 3 Operating a Copier with the Scanner/Plotter System(E) Installed
Acceptable/Unacceptable Paper
The following information pertains to what type of paper can and can
not be printed onto with the copier-printer.
G Acceptable paper
In Drawer 1 (optional), Drawer 2 and Drawer 3...
• Paper roll width: 8 1/2" to 36" [210 to 920 mm]
• Paper roll diameter: less than 6 3/4" [180 mm] or less
• Paper roll tube diameter: 3" [76 mm (75.2 to 77.2 mm)]
8 1/2" - 36"
210 - 920 mm
64 g/m
2
- 80 g/m
• Paper roll types:
2
Standard paper (64 g/m
to 80 g/m
Vellum
Film
In the manual feed table (Bypass) ...
• Paper sizes: 8 1/2" x 11" to 36" x 48"
[A4 portrait to A0]
• Paper width: 8 1/2" to 36" [210 to 920 mm]
• Paper length: 11" to 48" [297 to 1,189 mm]
• Paper types:
Plain paper (64 g/m
2
to 80 g/m
Vellum
Film
8 1/2" - 36"
210 - 920 mm
64 g/m
2
- 80 g/m
In case of Memory ...
Paper length differs depending on the memory used for this plotter.
In case of Memory: 256MB (standard for this plotter)
•Paper length: 11" to 118" [297 to 3,000 mm]
In case of Memory: 512MB
•Paper length: 11" to 236" [297 to 6,000 mm]
3-2
2
2
)
2
)
2
G Unacceptable paper
• Any paper other than that indicated under "G Acceptable paper" at
left.
• Paper that is stapled, etc.
• When using paper rolls that are wrinkled, folded or torn, unroll the
paper until there are no more such defects and cut off the portion
with the wrinkles, folds and/or tears before use.
NOTE
Refer to the Operation Guide for your copier for information on
replenishing paper.
Advertisement
Table of Contents
Troubleshooting
