Name Settings [Changing The Work Group And Host Names]; Auto Shut-Off Settings [Changing The Auto Shut-Off Settings] - Kyocera Scanner/Plotter System (E) Operation Manual

Chapter 2 Set-Up (Copier)
Name Settings
[Changing the Work Group and Host Names]
Perform this procedure in order to register the required name
settings [the Work Group name and host name] for copier with the
Scanner/Plotter System(E) installed. The WEBINTERFACE is utilized
to make these settings.
NOTES
• Since there is a danger of communications trouble occurring if
another computer on your network is using the same computer
name, be sure to consult with your network manager in advance
when selecting the name that you want to use for the copier.
• Be sure to use the same name for both the copier's Work Group
name and host name.
• Use the Internet Explorer browser application on another client
computer in order to access the WEBINTERFACE.
• In order to use the WEBINTERFACE it is necessary to register the
correct IP address in the copier in advance. Refer to "Network
Settings [Configuring the IP Address, etc.]" on page 2-2.
• While this section only explains how to set the Work Group name
and host name using the WEBINTERFACE, Web manager is
convenient for a number of uses. Refer to the On-Line Manual for
more detailed information.
1 Start up a client computer that can access the copier
(Scanner/Plotter System(E)) over the network.
2 Run Internet Explorer in that computer.
3 Enter the following URL:
http:// <IP address of the copier that has the Scanner/Plotter
System(E) installed> /
NOTE
The current IP address can be verified in the "Network Settings
[Configuring the IP Address, etc.]" procedure on page 2-2.
2-4
Auto Shut-Off Settings
[Changing the Auto Shut-Off Settings]
Your copier has an Auto Shut-Off function that engages to
automatically turn the main switch OFF (
for a designated period of time.
If the default mode for the Auto Shut-Off function is set to [Shut off
mode], be sure to change it to [Sleep mode]. Doing this will allow the
copier to enter an energy-saving state whenever the copier is not
used for that designated period of time, but it will be able to recover
from this state quickly when print and scan commands are received
from the computer.
Refer to the Operation Guide for your copier for the procedure to
change the setting for the Auto Shut-Off function.
) if the copier is not used